Download V800_F7_PVF - Elevator Controls

Transcript
Introduction
The V800 Type P.V.F. system is a multi-computer network that controls the elevator. The P.V.F.
uses a Dual Feedback Servo-loop from the elevator's speed and position to produce the optimum ride and
performance. Figure I-1 is a block diagram of the P.V.F. multi-computer network.
Elevator Controls Position Velocity Feedback system is composed of three basic elements, in
addition to the relay logic interface circuitry. These elements are:
1. Elevator Car Controller Computer. It controls all of the elevator sequencing
and signals. The elevator computer is the master computer, and tells the Smart Drive
Interface (SDI) and the Speed Regulator what to do.
2. Smart Drive Interface (SDI). The SDI has the responsibility to generate the
optimum speed pattern. The SDI receives quadrature pulses from the position
transducer. The SDI keeps track of the elevator position to within 3/16 of an inch. This
position along with field adjustable variables is used to generate an optimum speed
pattern that is fed into the speed regulator. A manual titled SDI USER’S MANUAL is
provided under separate cover to cover the SDI functions in full detail. You will need to
procure a copy of the SDI manual to use as instructed in this manual.
3. Speed Regulator or drive system (Yaskawa – F7 drive, please refer to F7 Drive
User Manual -herein referred to as "drive manual" for details on this drive). The speed
regulator has the responsibility to make the elevator follow the speed pattern produced
by the SDI and control the actual speed and ride of the elevator.
This Manual deals with the installation and adjustment of the complete system and it is intended for
use in conjunction with the SDI and drive manuals captioned above.
IMPORTANT: The position transducer on cartop uses optical sensors to read tape-holes. It is
important to keep the sensors and reflector clean from dust and debris, particularly on new installations
4