Download - Schaeffler Group

Hydraulic mounting and dismounting
The high pressure pump, Figure 6, is suitable for the mounting and
dismounting of rolling bearings for shaft diameters up to 250 mm.
Due to the high oil pressure available, the pump can also be used
to expand and mount heavy shaft couplings and gears by means
of the hydraulic method.
The high pressure pump can be connected directly or by means of
thick-walled adapters. It can also be connected by means of a pump
holder and a 2 m long, flexible high pressure pipe. The oil pressure
in this case must not exceed the maximum oil pressure, see table.
Always operate the pump together with a manometer.
00019F0E
High pressure pump
Figure 6
High pressure pump
Available high pressure pump
Ordering example
Ordering designation
Further information
42
IS 1
Designation
Connector
Oil container
capacity
Delivery volume
per stroke
Maximum
oil pressure
l
cm3
bar
PUMP2500-0,2L
G3/4
0,2
0,3
2 500
PUMP4000-0,2L
G3/4
0,2
0,3
4 000
High pressure pump with maximum oil pressure of 4 000 bar
PUMP4000-0,2L
■ For detailed information, see TPI 195, FAG Pressure Generation
Devices.
■ Enquiries: [email protected],
+49 2407 9149-66.
Schaeffler Technologies