Download User Manual - Excalibur Engineering
Transcript
Analyzing PCI Performance Sample Advanced Performance Setup Sample Advanced Performance Setup To explain how to program an advanced performance measure, an example shows how to measure the proportion of non-idle cycles in PCI traffic. The required sequencer setup is quite simple. It uses the pattern term pt4 as follows: • pt4: b_state=Idle This makes pattern term pt4 sensitive to idle cycles. The sequencer of performance measure 1 is programmed to remain in state 0 only, incrementing counter A and B if their enable conditions are true: • Counter A must be incremented with each non-idle cycle. Therefore, pattern term pt4 must be inverted. • Counter B must be incremented with each clock cycle. The sequencer description table must be set up as follows: Table 3 NOTE 66 Sample Sequencer Description Table State Next State Transition Condition Counter A Enable Condition (Output) 0 0 1 !pt4 Counter B Enable Condition (Output) 1 In the table above, only those columns are shown that need to be programmed for the example. Agilent E2925B PCI Analyzer User’s Guide, August 2002