Download caution - Schneider Electric

Transcript
Generic Process
RatioCtrl_St Derived Data Type
Structure Description
The following table describes the structure of the derived data type RatioCtrl_St
for the RatioCtrl block:
Element
Type
Description
ManTotalISP
REAL
Manual total set point
TotalSP
REAL
Total set point output
TotalSPH
REAL
Total set point high limit
TotalSPL
REAL
Total set point low limit
TotalSPcalc
REAL
Calculated total set point output
TotalPV
REAL
Total process value
AutoRatiox (x: 1...6)
REAL
Auto mode ratio set point x (x: 1...6)
Ratiox x (x: 1...6)
REAL
Final ratio x (x:1...6)
ManSPx (x:1...6)
REAL
Manual mode set to point x (x: 1...6)
SPxcalcx (x: 1...6)
REAL
Calculated set point x (x: 1...6)
SPx (x: 1...6)
REAL
Set point x (x: 1...6)
SPxH (x: 1...6)
REAL
Set point x (x: 1...6) high limit
SPxL (x: 1...6)
REAL
Set point x (x: 1...6) low limit
PVx (x: 1...6)
REAL
Process value x (x: 1...6)
MAXPVDev
REAL
Maximum process value deviation permissable
TMAXPVDev
INT
Time delay for maximum process value
deviation error
TRatioError
INT
Time delay for ratio error
TSPError
INT
Time delay for set point error
Ctw
WORD
Control word to interact with HMI
Stw1
WORD
Status word 1 to interact with HMI
Alw1
WORD
Alarm word 1 to interact with HMI
Dummy1
WORD
Not used
Dummy2
WORD
Not used
Bit description for the Ctw element:
572
Bit
Description
0
Auto
1
Manual
2
Not used
EIO0000000886 07/2011