1
Download caution - Schneider Electric
Transcript
Cement Process Parameter Type Description Details ExtTotalSP REAL External total set point z Applicable in External and Auto External ratio for set points x (x: 1...6) Applicable in External modes only. Set poins are generated based on the external ratio inputs. Output 1...6 x (x: 1...6) enable z OP1Enx (x: 1...6) = 1: Output x is ExtRatiox (x: 1...6) REAL OP1Enx (x: 1...6) BOOL modes only if the ExtTotalSPEnable is selected from popup. z In External mode, it is divided into individual set points based on the ratio input pins. In Auto mode, it is divided into individual set points based on the ratio entered by operator from HMI. z Must be connected from other blocks (For example, Systems (Expert control systems) or PID Controller). controlled by the block. z OP1Enx (x:1...6) = 0: Output x is not controlled by the block. CAUTION UNINTENDED MACHINE OR PROCESS BEHAVIOR Be sure of the state of security of your machine or process environment. The AlmInh parameter to inhibit alarms muste be used very carefully. Failure to follow these instructions can result in injury or equipment damage. The following table describes the input parameter of the MultiFuelCtrl block: Parameter Type Description Details AlmInh BOOL Alarm inhibition z AlmInh = 1: Except for safety alarms, all the other alarms are inhibited. No alarms are generated by the block. z AlmInh = 0: Alarms are not inhibited. EIO0000000886 07/2011 493
