Download - Goddard Design Co.

If supported, this item controls the brightness of the configuration display on the RDM responder.
The next seven menus read the status of the responder on entry and write back the status on exit.
11.6.3 Display Invert
Some responders can rotate the displayed characters on the configuration display.
11.6.4 Pan Invert
Obvious, isn’t it?
11.6.5 Tilt Invert
See above.......
11.6.6 Pan / Tilt Swap
You’ve got this, right?
11.6.7 Lamp State
|LAMP STATE 'OFFµON|
| STRK STBY NONE ERR |
The standard defines the following lamps states
DMXter
E1.20 Name
ON
LAMP ON
OFF
LAMP OFF
No demonstrable light output
STRK
LAMP STRIKE
Arc-Lamp ignite
STBY
LAMP STANDBY
Arc-Lamp Reduced Power Mode
NONE
LAMP NOT PRESENT
Lamp not installed
ERR
LAMP ERROR
(We are not sure how one sets a lamp error, but it is
allowed.)
E1.20 Description
11.6.8 Lamp ON Mode
The standard supports the following modes for when an arc lamp should strike
DMXter
E1.20 Name
E1.20 Description
OFF
OFF
Stays off until directly instructed to Strike.
DMX
DMX
Lamp Strikes upon receiving a DMX512 signal.
ON
ON
Lamp Strikes automatically at Power-up
ONHOME
AFTER_CAL
The Lamp Strikes after Calibration.
11.6.9 Power State
DMXter
E1.20 Name
E1.20 Description
OFF
POWER_STATE_FULL_OFF
Completely disengages power to device. Device can no
longer respond.
MiniDMXter4 V3.19
41