Download 50 The SDL Simulator

Transcript
Chapter
50
The SDL Simulator
•
Immediately after a symbol or assignment statement where a variable is changed matching a variable breakpoint set by the command
Breakpoint-Variable.
•
When there is no transition that can be executed, that is, the system
is completely inactive. (On UNIX, if no environment is present and
the command Go-Forever was issued.)
•
Immediately after a symbol that included an SDL semantic error.
•
In the Simulator UI, when the Break button is clicked in the Execute
button module; in textual mode, when <Return> is pressed during
the output of trace information. The interactive monitor then becomes active directly after the current symbol has been executed.
Note:
No other characters may be typed before <Return> is pressed.
Syntax of Monitor Commands
The monitor system waits for commands from the user by issuing the
following prompt:
Command :
The syntax to be used for the commands and their parameters are described in the following.
Command Names
A command name may be abbreviated by giving sufficient characters to
distinguish it from other command names. A special character, the hyphen (-), is used to separate command names into distinct parts. Any
part may be abbreviated as long as the command name does not become
ambiguous.
Consider, as an example, the command name List-Process. The command name may be typed List-P or L-P. However, if only List is
typed, the monitor system will respond with the message
Command was ambiguous, it might be an abbreviation
of:
2064
,um-st1
Telelogic Tau 4.5 User’s Manual
July 2003