Download RoverBase User`s Guide

84
10.5
MobileCollect Mobile Module
RoverBase Wireless
LED Error Codes
There are several LED blink sequences associated with the Mobile Module. These blink
sequences provide information to the user about reading failures, wireless transmission failure,
low battery, etc. Normally the user only needs to be concerned with the error code sequences
shown in the table below.
LED Error Codes for Typical Operation
What You Observe
Things to Check
You press the Read button and after a The Mobile Module could not get a reading from
few seconds, the red Gage Read LED the gage.
flashes several times.
Is your gage turned on and is the gage
cable connected to the gage?
Do you have a defective gage cable?
You press the Read button and the red You got a reading from the gage, but you did not
Gage Read LED comes on. However, receive an acknowledgement that the data was
the green Handheld Accept LED blinks received by the handheld.
several times.
Have you associated the Mobile Module
with RoverBase?
Are you within range of the RoverBase?
You press the Read button and both
the red Gage Read and green
Handheld Accept LEDs come on
steady for a brief period. After the
LEDs turn off, the red Gage Read LED
blinks several times.
Copyright © 2012 MicroRidge Systems, Inc.
You got a gage reading and the measurement
packet was received by the handheld. However,
you have a low battery condition in the Mobile
Module. You should replace the battery as soon
as possible.