Download User`s Manual(current)

Transcript
Dual Half-bridge Mode Example
Figure 5. MegaMoto half-bridge mode
Function
Enable
PWMA
PWMB
Current Sense
Jumper
5V
D6
D10
MA – A3
MB – A0
Notes
Both power chips are always enabled and
cannot be disabled via program control
when the jumper is in this position
Timer0 PWM0A
Timer1 PWM1B
Each half-bridge is reported on a different
analog pin
Half-bridge mode is used for uni-directional loads such as fan motors, pumps, lights, solenoids
and other loads that don’t need to reverse direction. A single MegaMoto may control two
motors independently in this mode. Also, a brushless motor may be controlled using two
MegaMotos to provide three half-bridge circuits. Three MegaMoto units can supply six halfbridges so two brushless motors may be controlled by a full stack of three MegaMotos on a
single Arduino base.
Version 1.5 - December 11, 2010
7