Download FAG Motion Guard CONCEPT6, Automatic single

Transcript
The operating condition of the lubricator can be determined from
the green and red LEDs and from the display on the control unit,
Figure 11.
The settings for the lubricator can be performed using the keys und and monitored on the display. Error messages generated
when there is excessive pressure in the lubricant feed line for
example, are also displayed.
LC display
Red LED
“OFF/ON SELECT” key
FAG C6-MP-DISTRIBUTOR connector
(for up to 6 lubrication points)
Green LED
“MODE SAVE” key
1
2
Figure 11
Display and control keys
on the drive
6
3
4
5
141 264
Display and controls
4
Function displays
Display
LED signals
Schaeffler Group Industrial
The “--” display cannot be deactivated, irrespective of the condition
of the battery set. Settings, operating conditions and error
messages relating to the lubricator are shown on the display,
Figure 11 .
During defect-free operation, the display shows the residual volume
of the fitted LC unit in percent volume (% vol.).
The LEDs on the drive, Figure 11 and , are interpreted as
follows:
LED lit
Signal
Green
Flashing
every 10 seconds System running
Description
Red
Flashing
every 3 seconds
Error or malfunction
Green and red
Flashing
every 3 seconds
Replace LC unit immediately
Green
Continuous
Motor running;
dispensing operation
BA 10
13