Download FAG Motion Guard CONCEPT6, Automatic single

Transcript
During operation
Special dispensing operations
Machinery downtime
Check regularly:
■ Seal integrity of the lubricator, the feed lines and the connections
■ Lubricant fill level
■ Correct position and finger tight screw mounting of all
components.
Calculate the modified dispensing time and incorporate this into
the remaining running time of the lubricator and into the lubrication
and maintenance plan.
Malfunctions
If the control system is showing a malfunction, the reason will
appear on the display. Further information is contained in the defect
table on page 24.
Deactivation
Hold the “ON/OFF SELECT” key down for longer than 4 s, until
the residual volume display Figure 13 , page 16, disappears and
is replaced with the display “--”. All lubricator settings remain
stored so that the program can continue from the point at which it
was stopped upon reactivation.
Schaeffler Group Industrial
BA 10
17