Download FAG Motion Guard CONCEPT6, Automatic single

Procedure for replacing the LC unit
Schaeffler Group Industrial
Work steps:
■ Rotate the cover on the drive in an anti-clockwise direction and
remove.
■ Remove the empty LC unit; “LC” will appear on the display and
the red LED will flash.
■ Remove the sealing cap from the new LC unit, Figure 8, page 11.
■ Push the LC unit into the cover until the lubricant works its way
out of the outlet, Figure 9, page 12.
■ Fit the LC unit, rotate until the catch locks into place and
the teeth of the LC unit and the drive engage with each other.
The lubricator's control system automatically detects the new LC
unit. “--” appears in the display if the device was previously
deactivated, or “99 % vol.” if the device was activated prior to
the changeover.
■ If the lubricator was activated, it will continue to work with the
previous running time setting. If not, activate.
■ Where necessary, change the configuration of the lubricator,
page 18.
BA 10
23