1
Download Reference Manual Command Line Interface L2P
Transcript
4.8 Device Configuration Commands
4.8.14 monitor session <session-id> source/
destination
This command allows you to configure and activate the port mirroring function of the switch. Port mirroring is when the data traffic of a source port is
copied to a specified destination port. The data traffic at the source port is not
influenced by port mirroring. A management tool connected at the specified
port, e.g., an RMON probe, can thus monitor the data traffic of the source
port.
Note: In active port mirroring, the specified destination port is used solely for
observation purposes.
Default
none
Format
monitor session <session-id> {source | destination}
interface <slot/port>
Mode
Global Config
U no monitor session <session-id> source/destination
This command resets the monitor session (port monitoring) source/destination.
Format
no monitor session <session-id> {source | destination} interface
Mode
Global Config
140
CLI L2P
Release 4.2 09/08
