Download ICEbear User Manual

Transcript
Figure 5.1: JTAG pinout, top view
Never use the ICEbear software with similar, modified JTAG adapters. It may
damage your target.
Note the missing pin 3 for the key. The pinout is displayed mirrored, i.e. just as you normally
see it when plugging the adapter into the target JTAG.
The LED on the ICEbearPlus models monitors, whether the JTAG device is accessed (’opened’)
by the Host PC. This is an auxiliary for factory programmers to determine whether an operation
has completed and that it is safe to unplug from the target.
v1.53
40