Download ICEbear User Manual

Transcript
When removing the ICEbear, hold the bottom connector firmly with two fingers and gently
wiggle it out lengthwise. Do not apply too much force to not bend your JTAG pins or stress
your PCB. The JTAG connector is a high quality header that withstands thousands of
connection cycles, but less stress will extend its lifetime.
1.6
Running the software
To test whether the adapter can talk to the target, execute one of the examples, for instance in
Linux:
icebear-dumpreg
or Run Demos from the ICEbear program menu in Windows.
If everything is properly connected, this will give you a register dump of the current cpu state.
Alternatively, you can start gdbproxy and fire up the debugger – see next chapter.
The ICEbear debugger toolchain is a very powerful and complex environment
that manipulates hardware directly. Make sure you read the manual thoroughly
and follow the Application Notes to get a feeling for the behaviour of the debugger.
1.6 Running the software
v1.53
8