1
Download - Service, Support
Transcript
VARI (machining type) The machining type can be found in the table below. Value Longitudinal/face Ext./int. Roughing/finishing/complete 1 L O Roughing 2 3 4 P L P O I I Roughing Roughing Roughing 5 6 7 L P L O O I Finishing Finishing Finishing 8 9 10 11 P L P L I O O I Finishing Complete machining Complete machining Complete machining 12 P I Complete machining In longitudinal machining, the infeed is always carried out along the transversal axis, and in face machining - along the longitudinal axis. External machining means that the infeed is carried out in the direction of the negative axis. With internal machining, the infeed is carried out in the direction of the positive axis. The VARI parameter is subjected to a plausibility check. If its value is not in the range 1 ... 12 when the cycle is called, the cycle is aborted with alarm 61002 "Machining type defined incorrectly". 166 Programming and Operating Manual (Turning) 6FC5398-5DP10-0BA3, 08/2015
