Download 1 Contents Chapter 1 Introduction

58
CHAPTER 7
Maintenance
Code Description
Probable Cause
Solution
16
An appropriate delivery
system is not in place.
Verify that the delivery
system uses a Convergent
compatible connector.
Fiber is faulty or heavily
damaged.
Replace fiber.
Remote connector
missing.
Verify that the remote
connector, located on
the back panel, is seated
securely.
An external device caused
the remote interlock
circuit to disable the laser
system.
Re-engage the remote
interlock with the
external source
17
18
27
Delivery system not
connected
Remote interlock open
Foot switch not
connected
Blast shield error
Verify that the connector
is screwed down finger
tight.
An appropriate foot switch Verify that the foot switch
is not in place.
connector, located on
the back panel, is seated
securely.
The foot switch connector
is damaged.
Call for service.
Blast shield motor or
optical sensor error.
Call for service.
Blast Shield installed
backwards.
Call for service.
28
Laser output below
minimun
Laser resonator out
Call for service.
of alignment or laser
resonator mirror damaged.
29
Laser output 100%
above set point
System requires
re-calibration.
See Power Calibration in
this chapter.
Error spike injected into
high power electronics.
Turn OFF laser system
and restart after
30 seconds.
Odyssey 30 B User’s Manual