Download User`s Manual

* In -Development
4.0 Getting Started
The standard CMT kit includes the following items:
 CMT unit
 CMT full breakout cable (GMS p/n 780-C0291)
(Power, A/V input, User Data, Control interfaces)
NOTE: Based on customer application GMS may deliver a receiving system, additional cables and
antennas. Contact GMS for further information.
The CMT is pre-configured by GMS prior to shipment (based on customer requirements), thus is ready
to work “right out of the box”.
4.1
Initial Checkout
Prior to installing a CMT unit into the desired target environment, an initial checkout should be
performed to ensure proper operation of the unit. The initial checkout consists of configuring a
basic CML link.
Figure 1 shows a basic standard CML wireless link configuration. (NOTE: MSR and D/C units and
their associated hardware are sold separately). The steps necessary to setup the configuration
shown in Figure1 are shown below. High throughput optional CMTs require additional hardware
(which includes two MSRs, a DDP plug in card and a combiner).
Figure 1 - Basic CML Link Setup
100-M0071X2B
8 of 42
www.cobham.com/gms