Download User`s Manual
Transcript
Chapter 6 Description of Function Parameters
F5.11 AFM gain setting Setting range: 20~200%
Default value: 100%
F5.12 Remain
F5.13 DFM gain setting Setting range: 20~200%
Default value: 100%
F5.14 Remain
Parameter F5.11 defines the upper limit value for analog output AFM.
If the default value is 100% and the range of output voltage/current is
0.00~10.00V/0.00~20.00mA, then the voltage and current output will
be selected by the jumper.
AFM output = (0~10V/0~20mA) F5.11(Maximum value 10V/ 20mA)
Parameter F5.13 define the upper limit value for digital output DFM. If
the default value is 100%, then the range of output frequency will be
0.0~10.0KHz.
DFM output = (0~10KHz) F5.13 (Maximum value =20KHz)
F5.15 Combined feed path setting Setting range: 000~666 Default value: 000
This parameter is used to set the frequency feed path.
LED units digit: Operation figure 1
0: Keyboard potentiometer
1: Digital feeding 1
2: Remain
3: Digital feeding 3
4: AVI
5: ACI
6: Digital feeding 2
LED tens digits: Operation figure 2
0: Keyboard potentiometer
1: Digital feeding 1
2: Remain
3: Digital feeding 3
4: AVI
-94-
Chapter 6 Description of Function Parameters
5: ACI
6: Digital feeding 2
LED hundreds digit: Operation figure 3
0: Keyboard potentiometer
1: Digital feeding 1
2: Remain
3: Digital feeding 3
4: AVI
5: ACI
6: Digital feeding 2
LED thousands digit: Remain
F5.16 Combined feed algorithm setting Setting range: 00~54 Default value: 00
This function is used to set the combined feed algorithm.
LED units digit algorithm 1
LED tens digit Algorithm 2
0: Addition
0: Addition
1: Subtraction
1: Subtraction
2: Absolute value (subtraction)
2: Absolute value (subtraction)
3: Take the maximal value
3: Take the maximal value
4: Take the minimum value
4: Take the minimum value
5: Operating figure 3 does not participate in algorithm.
LED hundreds digit Remain
LED thousands digit Remain
Parameter F5.15 and F5.16 will be valid only when F0.01=7. Its
algorithm formula is shown below:
(Operation figure 1) Algorithm 1 (Operation figure 2) Algorithm 2
(Operation figure 3)
If the tens digit of F5.16 is set to 5, the operation figure 3 will anticipate
in algorithm composed of two figures (operation figure 1 and operation
figure 2).
Eg.1: If F5.15=534 and F5.16=10, then the algorithm pair will be:
{(AVI + digital feed 3) ACI}
Eg.2: If F5.15=460 and F5.16=21, then the algorithm pair will be:
|(Keyboard potentiometer- digital feed 2) AVI|
-95-