Download VRC 4000 Software Driver Manual

Appendix B: TBDriver Switch Settings and Hardware Notes
Dynapro - Bus
J2Touch mode
Ellinor Touchscreen
J1
J2
Don't care
1-2
Continuous/transmit on touch
Binary Mode
Elographics Accutouch - CRC Controller
SW1-1,2,3
SW1-4,5
SW1-6,7,8
SW2-1
SW2-2,3
SW2-4,5
SW2-6
On,On,On
Off,On
Off,Off,On
Off
Off,Off
Don't care
Off
(9600 baud)
(Continuous mode)
(Binary mode)
(Run mode)
(Identifier Tag)
The setup procedure for this controller must be performed before it is used
with TBdriver.
Elographics Accutouch E271-141 PC Bus Controller
Default Base I/O Port = 280 hex
Default IRQ = 5
SW1On(12 bit mode)
SW2On(No calibration)
SW3Off(Stream mode)
SW4On(Filtered mode)
B-5