Download Seagate Crystal Reports

Transcript
7272
How to enable/disable job offset.
Solution
To enable/disable job offset, perform the following:
1. Press the HELP key.
2. Press Key Operator Mode which is displayed on the touchscreen.
3. Touch the down-arrow on the lower left corner of the touchscreen.
4. Touch [13 Memory switch setting] on the touchscreen.
5. Touch the down-arrow on the lower left of the touchscreen three (3) times.
6. Touch the down-arrow on the right side of the touchscreen (5) times. The highlighted indication will shift to [20 JOB offset operating] and the current
setting will be displayed on the touchscreen.
7. Touch [Change Setting Contents] on the lower middle of the touchscreen until the desired setting is displayed. The setting choices available are [OFF],
which is the default setting or ON.
8. Press RETURN on the touchscreen a couple of times to return to normal mode.
Solution ID
TAUS0626470EN*
Solution Usage
3
Description
PK120A, PLEASE CANCEL PUNCH MODE OR CHANGE PAPER SIZE message when selecting 2-hole punch for 8.5x11R or 8.5x14 paper.
Solution
CAUSE: Improperly programmed software dipswitch settings.
SOLUTION: To input the proper software dipswitch settings, perform the following:
1. Power the copier OFF.
2. Access the 25 mode (power the copier ON, while pressing the 2 and 5 keys).
3. Touch [1. Software SW setting) on the touchscreen.
4. Use the up/down arrows and scroll to software dipswitches 22-1.
5. Touch [OFF (0)] on the touchscreen.
6. Use the up/down arrows and scroll to software dipswitches 22-2.
7. Touch [OFF (0)] on the touchscreen.
8. Power the copier OFF/ON to exit the 25 mode.
Solution ID
TAUS0627855EN*
Solution Usage
3
Description
PK120, F77-44 at power up.
Solution
CAUSE: The finisher CB has failed.
SOLUTION: To check the finisher CB, perform the following:
1. Power the copier ON.
2. Using a voltmeter (set to 200V DC range) check the voltage output at CN61-1 on the finisher CB, a reading of 24V DC should be present. If, a reading of
0V DC to 4V DC is measured an ICP on the finisher CB has opened.
3. Ensure, the wiring harness between CN61 on the finisher CB and CN64 on the PKDB is not pinched. Also, ensure that both the punch motor (M801) and
punch shift motor (M802) rotate freely. After, determining the model finisher installed on the machine order the appropriate finisher CB as necessary.
Solution ID
TAUS0628792EN*
Solution Usage
3
Solution Usage
3
Description
FS210M, part number for the finisher CB.
Solution
Finisher CB (p/n 14JT-9011).
Solution ID
TAUS0628799EN*
Description
PK120, J72-43 when punching 1:2 or 2:2 copies only.
Solution
CAUSE: Improper EPROM firmware level installed on the PK120.
SOLUTION: Upgrade the PK120 EPROM firmware level to version 11 or higher. The EPROM file (PK120-11r.exe) can be downloaded from KoniNET and is
listed under EPROMs for accessories.
Copyright 2009, Konica Minolta Business Solutions U.S.A., Inc.
June 2009
47