Download Velmex 8601 User manual

Single Step mode is provided for debugging programs or as a controlled interrupt.
The Control can be polled for its status at any time; additionally a ready prompt (">") is automatically sent
to the host when a program has finished.
Capable of running large motors, up to 10 amps total (5 amps/phase).
Twelve month Limited Warranty.
SETUP
* * CAUTION * *
* HAZARDOUS VOLTAGE, DO NOT REMOVE CONTROL PANELS
OR COVER
* DO NOT CONNECT OR DISCONNECT MOTOR WHEN POWER
IS "ON"
* HIGH TEMPERATURE, CONTROL SHOULD BE KEPT AT LEAST
6 INCHES FROM ANY OBJECTS
* AIR MUST CIRCULATE THROUGH AND AROUND CONTROL,
DO NOT BLOCK AIR VENT IN BOTTOM OF CONTROL
* NEVER USE IN AN EXPLOSIVE ENVIRONMENT
* IN INDUSTRIAL ENVIRONMENTS, THE CONTROL MUST BE
PROTECTED TO PREVENT METAL CHIPS FROM FALLING
INTO IT
* SEVERE ELECTRICAL DAMAGE MAY RESULT IF OBJECTS
FALL INTO THE CONTROLS HEAT SINK
1. Connect cables to motor and limit switches.
CAUTION: Never connect or disconnect motor with power ON, this may result in severe damage to
motor drives.
2. Plug Control into 120VAC outlet.
4