Download PDF

11.39 Maximum flow limit
network input SNVT_time_sec nciSndHrtBt;
Network input config SNVT_flow_p nciFlowHighLim;
This network configuration property input sets the maximum
period of time that will elapse before the functional block
automatically updates the following network variables:
This configuration property defines the maximum limit of the flow
of the pump. Applies to MAGNA3 and TPE 2000 version H and
later only. It can be enabled in all control modes.
nv3, nvoPumpCapacity
Valid range
nv4, nvoEffOpMode
The valid range is 0.0 to 655.34 m3/h.
nv5, nvoControlMode
nv13, nvoPumpStatus.
A value of 0xFFFF (655.35 m3/h) represents invalid data and will
disable the flow limit function.
Valid range
Default value
0.0 to 6,553.4 sec. (0.1 sec.).
The default value is 0xFFFF, i.e. disabled.
A value of 0xFFFF (6,553.5 sec.) represents invalid data and will
disable the automatic update function.
Product availability
A value of zero (0) will be used for the internal timer if the
configured value is invalid. The value of zero (0) disables the
"send heartbeat" function.
Only available on MAGNA3.
H
Default value
The default value is 0.0 (no automatic update).
Product availability
For product availability, see overview on page 36.
11.37 Receive heartbeat
This network configuration property input sets the maximum
period of time that will elapse before the functional block
automatically uses the default values for the following network
variables:
nv10, nviRemotePress
nv11, nviRemoteFlow.
Q
TM05 2950 0712
network input config SNVT_time_sec nciRcvHrtBt;
Fig. 17 Maximum flow limit
Valid range
0.0 to 6,553.4 sec. (0.1 sec.).
A value of 0xFFFF (6,553.5 sec.) represents invalid data and will
disable the automatic update function.
A value of zero (0) will be used for the internal timer if the
configured value is invalid. The value of zero (0) disables the
"receive heartbeat" function.
Default value
The default value is 0.0 (no automatic update).
Product availability
For product availability, see overview on page 36.
11.38 Control mode for normal operation
network input config SNVT_dev_c_mode
nciControlMode;
This network configuration property input defines the device
control mode to be used for the normal operating mode.
For more details about the control modes, see section
11.6 Effective device control mode.
Valid range
The valid range is the same as that of nvoControlMode.
Default value
The default control mode for a pump is DCM_PRESS_COMP
(value = 2).
Product availability
For product availability, see overview on page 36.
31
English (GB)
11.36 Send heartbeat