Download SLM Utility G3 Manual

Stop a Measurement
Left click Stop, as shown in FIGURE 3-38, to put the
instrument into the Stop mode and terminate a
measurement.
Run Status
FIGURE 3-38 Stop Key
When the instrument is stopped, the Run Status will change
to “STOPPED”. Also, the Session Log will be updated to
reflect the stopped status of the instrument, along with the
data and time of the stop, as shown in FIGURE 3-39.
FIGURE 3-39 Session Log: Stopped
Reset Current Data
Warning: Exercise caution when
using this action since deleted data
cannot be recovered. Data you wish
to keep should be stored to a file,
which will also reset the current
data, prior to using the Reset
Current Data function.
To clear the current data memory of the connected
instrument, left click Reset Current Data as shown in
FIGURE 3-40.
FIGURE 3-40 Reset Current Data
SLM Utility-G3 Manual
Manual Control Page
3-33