Download User Manual - Melco Tech

Digitizing & Editing Preferences
Your digitizing style and preferences are usually fairly personal. To customize the software to better fit
your style, access the Preferences tab.
To change your digitizing preferences:
1. Go to the Tools menu and select Options.
2. Click on the Preferences tab.
3. Select your preferences.
• Point Size - This slider changes how large or small the
wireframe points are displayed.
• Constrain Line Angle - When holding ALT to constrain the
line angle while digitizing, this field will specify the degree
of constraint.
• Auto Scroll - While using a input tool, if you nudge the
side of the view window, it will automatically begin to
move with the cursor. This setting enables this feature and
controls the speed.
• Digitizing Cursors - This allows you to select the cursor
seen when using a digitizing input tool.
•
Small Crosshair
•
Large Crosshair
•
Arrow
•
Small Eye Crosshair
•
Large Eye Crosshair
• Full Screen Crosshair
• Digitizing Sound - Check this box if you would prefer to here a beep for every wireframe point
digitized.
• Lower tones indicate straight points.
• Higher tones indicate curve points.
4. Click OK to affect the changes.
134 of 216
Table of Contents