Download as a PDF

Opt-file Name
SAMPL Name
Description
USE FORTMP SPECS
UseFortMPSpecs
Flag specifying whether to use extra SPECS-command file (only with
the FortMP solver.)
A SPECS command file with the name fortmp.spc may be used to
refine the options when FortMP is the solver in use. See the FortMP
manual (Ellison et al., 2008). Commands are to be provided in sections corresponding to the type of sub-problem that is being solved,
according to the following table:
Section ID Description
ALL
Value
Default
Section that applies to every call to the solver.
Must appear first in the SPECS file.
DeqImna
Section to handle Deterministic Equivalent Implicit NA
DeqExna
Section to handle Deterministic Equivalent Explicit NA
ExpVal
Section to handle Expected Value solutions
Wsprob
Section to handle Wait and See scenario subproblems
BendRoot Section to handle Benders root-node subproblem solutions (multi-stage)
BendNode Section to handle Benders node sub-problem
solutions other that root or leaf (multi-stage)
BendLeaf Section to handle Benders leaf sub-problem solutions with no warm restart (multi-stage)
BenRLeaf Section to handle Benders leaf sub-problem solutions with warm restart (multi-stage)
Ben2Mast Section to handle Benders master-problem solutions (two-stage)
Ben2Sprb Section to handle Benders sub-problem solutions (two-stage)
LevelQP
Section to handle Benders Level-method QP
solutions (two-stage)
The section ID is named in a BEGIN line - e.g. BEGIN (DeqImna) which is followed by the SPECS commands for that section. Each
section is terminated with a line END.
Boolean
OFF
51