Download Technical and User Manual
Transcript
Every numeric information should be confirmed with the key the previous information which may be simply O (zero). .Otherwise the keyboard will keep STEP 1 -Enter the number on screen (1 to 7 digits) you want to give to this moulding or profile. In case of mistake, REFERENCE TO CREATE press CLR and start again. Confirm with . 0000300 -Page 1 of the Joining parameters comes up. -RETURN key brings you back to FILE MANAGER RETURN ? menu. STEP 2 1 2 3 REFERENCE 0000300 -Enter the moulding’s width (w/out rebate) in mm, MOULDIG WIDTH : 015 4 5 6 confirm with WHITE TRIANGLE 7 8 9 -Pressing the key of top presser types proposed by the SPACER 0 CLR machine, leave it on the top presser you want for this SIZE 5 moulding. Pushing on key SPACER (you will darken ENTER RETURN ? this key), you confirm that you want to use spacer bars with this profile. By pushing again, you cancel. 1 2 3 1 2 3 Pressing the wedge SIZE key several times, leave it POSITION 008 000 000 4 5 6 NUMBER 1 0 0 on the size & type you want (Hardwood “HW” or 7 8 9 4 5 6 normal –no mark after size). Press to access to the POSITION 000 000 000 0 CLR second screen of joining parameters. NUMBER 0 0 0 STEP 3 -Enter now the stapling positions (distances ENTER RETURN in mm from the back of moulding) and the number of wedges for each position. Confirm with every time. To move the cursor, use the keys and . TIP : If you want more than one stapling position, it would be wise to memorise the stapling positions from the smallest value (closest to the back) to the biggest value (closest to the rebate of moulding); the machine’s programme executing the assembly process exactly in the order memorised (from 1st to 6th position), this would make it work faster and create for the operator a bigger space to bring the corner out of machine.When all information has been given, press ENTER to memorise. The machine will propose you to go on Creating new references. RETURN key brings you back to FILE MANAGER, then to MAIN MENU. On all screens, the ? key provides you some help and short explanations. To create an article by VISUAL MODE , see page 14. JOINING FILES 1 2 3 4 5 6 7 8 9 0 CLR EXECUTION OF AN ARTICLE (JOINING A FRAME) EXECUTION MENU EXECUTE FILE EXEC. DIRECTLY or LAST JOB VISUAL MODE RETURN ? 1 4 REFERENCE TO EXECUTE 7 0000124 0 EXECUTE FILE 2 5 8 3 6 9 CLR RETURN ? On MAIN MENU, press EXECUTE. In EXECUTION MENU, there are 3 possibilities: 1) EXECUTE FILE; to assemble a frame with a moulding or profile that is in File memory; enter the article number and press to confirm. To correct a mistake in moulding number, press CLR and enter the item number again. RETURN key brings you back to previous menu. 9