Download Technical and User Manual

Transcript
Every numeric information should be confirmed with the key
the previous information which may be simply O (zero).
.Otherwise the keyboard will keep
STEP 1
-Enter the number on screen (1 to 7 digits) you want
to give to this moulding or profile. In case of mistake,
REFERENCE TO CREATE
press CLR and start again. Confirm with .
0000300
-Page 1 of the Joining parameters comes up.
-RETURN key brings you back to FILE MANAGER
RETURN ?
menu.
STEP 2
1 2 3
REFERENCE 0000300
-Enter the moulding’s width (w/out rebate) in mm,
MOULDIG WIDTH : 015
4 5 6
confirm with
WHITE TRIANGLE
7 8 9
-Pressing the key of top presser types proposed by the
SPACER
0 CLR
machine, leave it on the top presser you want for this
SIZE
5
moulding. Pushing on key SPACER (you will darken
ENTER
RETURN ?
this key), you confirm that you want to use spacer
bars with this profile. By pushing again, you cancel.
1
2
3
1 2 3
Pressing the wedge SIZE key several times, leave it
POSITION
008 000 000
4
5
6
NUMBER
1
0
0
on the size & type you want (Hardwood “HW” or
7 8 9
4
5
6
normal –no mark after size). Press to access to the
POSITION
000 000 000
0 CLR
second screen of joining parameters.
NUMBER
0
0
0
STEP 3 -Enter now the stapling positions (distances
ENTER RETURN
in mm from the back of moulding) and the number of
wedges for each position. Confirm with every time. To move the cursor, use the keys and .
TIP : If you want more than one stapling position, it would be wise to memorise the stapling positions from the smallest value (closest to the back) to the biggest value (closest to the rebate of
moulding); the machine’s programme executing the assembly process exactly in the order memorised (from 1st to 6th position), this would make it work faster and create for the operator a bigger
space to bring the corner out of machine.When all information has been given, press ENTER to
memorise. The machine will propose you to go on Creating new references. RETURN key brings
you back to FILE MANAGER, then to MAIN MENU. On all screens, the ? key provides you some
help and short explanations.
To create an article by VISUAL MODE , see page 14.
JOINING FILES
1 2 3
4 5 6
7 8 9
0 CLR
EXECUTION OF AN ARTICLE (JOINING A FRAME)
EXECUTION MENU
EXECUTE FILE
EXEC. DIRECTLY or LAST JOB
VISUAL MODE
RETURN ?
1
4
REFERENCE TO EXECUTE 7
0000124
0
EXECUTE FILE
2
5
8
3
6
9
CLR
RETURN ?
On MAIN MENU, press EXECUTE. In EXECUTION MENU, there are 3 possibilities:
1) EXECUTE FILE; to assemble a frame with a moulding or profile that is in File memory; enter
the article number and press to confirm. To correct a mistake in moulding number, press CLR and
enter the item number again. RETURN key brings you back to previous menu.
9