Download OpenBTS for dummies

Transcript
10.12
10.12
I’ve got a RFX 1800 daughterboard but would like to use the 900Mhz band10
TROUBLESHOOTING
I’ve got a RFX 1800 daughterboard but would like to use the 900Mhz band
You don’t need to buy another daughterboard: it’s possible to flash the hardware.
From RFX1800 to RFX900:
$ sudo ./burn-db-eeprom -A --force -t rfx900
TX_A: OK
RX_A: OK
(or -B for side B).
And back:
$ sudo ./burn-db-eeprom -A --force -t rfx1800
10.13
I’ve done everything just the same as you but it’s not working!
I’m sorry to hear that. Besides getting help from the OpenBTS mailing-list [ML], I would recommend you
check:
1. if you are on OpenBTS 2.6, you have applied all software patches (4)
2. switch your phones to manual GSM-only network research
3. in OpenBTS 2.6: the OpenBTS config file uses the Transceiver52M directory (for people using 52Mhz
clock)
4. in OpenBTS P2.8: check that you did that:
#(from OpenBTS root)
cd apps
ln -s ../Transceiver52M/transceiver .
10.14
smqueue reports an error ”Address already in use”
.
Disable ipv6 on the Linux box and the error should disappear.
10.15
smqueue crashes
smqueue crashes with the following message:
cannot find configuration value Log.Alarms.Max
terminate called after throwing an instance of ’ConfigurationTableKeyNotFound’
Aborted
The message gives you the answer: add a Log.Alarms.Max entry to smqueue.config (for example, set to 10).
10.16
smqueue complains: ”Failed to read queue from file savedqueue.txt”
.
This is a warning (not a fatal error). Smqueue will still run. Create savedqueue.txt in the ./smqueue directory
to remove the warning next times.
Page 37
OpenBTS for dummies