Download OpenBTS for dummies
Transcript
10.12 10.12 I’ve got a RFX 1800 daughterboard but would like to use the 900Mhz band10 TROUBLESHOOTING I’ve got a RFX 1800 daughterboard but would like to use the 900Mhz band You don’t need to buy another daughterboard: it’s possible to flash the hardware. From RFX1800 to RFX900: $ sudo ./burn-db-eeprom -A --force -t rfx900 TX_A: OK RX_A: OK (or -B for side B). And back: $ sudo ./burn-db-eeprom -A --force -t rfx1800 10.13 I’ve done everything just the same as you but it’s not working! I’m sorry to hear that. Besides getting help from the OpenBTS mailing-list [ML], I would recommend you check: 1. if you are on OpenBTS 2.6, you have applied all software patches (4) 2. switch your phones to manual GSM-only network research 3. in OpenBTS 2.6: the OpenBTS config file uses the Transceiver52M directory (for people using 52Mhz clock) 4. in OpenBTS P2.8: check that you did that: #(from OpenBTS root) cd apps ln -s ../Transceiver52M/transceiver . 10.14 smqueue reports an error ”Address already in use” . Disable ipv6 on the Linux box and the error should disappear. 10.15 smqueue crashes smqueue crashes with the following message: cannot find configuration value Log.Alarms.Max terminate called after throwing an instance of ’ConfigurationTableKeyNotFound’ Aborted The message gives you the answer: add a Log.Alarms.Max entry to smqueue.config (for example, set to 10). 10.16 smqueue complains: ”Failed to read queue from file savedqueue.txt” . This is a warning (not a fatal error). Smqueue will still run. Create savedqueue.txt in the ./smqueue directory to remove the warning next times. Page 37 OpenBTS for dummies