Download PC - AMS Users Manual

Slice Width
This specifies how monitoring window will be separated into slices for analysis.
The size of the slice is dependent on the total Data Acquisition for the channel.
The monitoring window is sliced into position dependent slices, and within each
slice, an average force is computed. Each slice has an associated upper and
lower limit, which is used when certifying the part.
Slice Tolerance
Slice Tolerance is used for widening the relative limits on a vertical rise. For each
upper limit slice drawn, it compares the actual slice and then X number of slices
before and X number of slices after the point and uses the highest value of the
three. The lowest value is used for the lower limit. Where X represent the value
of the Slice Tolerance set in the Advanced Setup.
Force
Monitoring W indow
Relative
Upper Limit
Relative
Lower Limit
Start of
W indow
Slice
Width
End of
W indow
Position
PC AMS User Manual •06/24/03 • Software Versions: 1.6.4
11429 East Grand River • P.O.Box 748 • Brighton, Michigan 48116 • (810) 229-9334 • FAX (810) 229-8125
E-Mail Address: [email protected] • Web Site: www.promessinc.com
-10-