Download A35 - Ortec

ScintiVision®-32 v2 (A35-B32)
LOCK “Pwd” [,”Name”]
This locks the current Detector using “Pwd” as the password. If the optional “Name”
parameter is missing, the Locked name defaults to “Job”. This password is retained in the
.JOB file and used with any .JOB commands so that the user does not need to re-enter the
password.
LOOP <repetitions> ... END_LOOP
This pair executes multiple times all the commands between LOOP and END_LOOP. The
number of execution times is specified by <repetitions>. Each command must be given on a
separate line. A value of 0 executes once. A LOOP with no END_LOOP statement executes
once.
The loop count value can be included in any text by typing three question marks in the text
where the loop count is to be inserted. The loop count replaces “???” with three characters
using leading zeros if necessary.
The loop variables, $(Loop) and $(LOOP1), can be included in any text. The loop count will
be inserted with leading zeros suppressed.
The following is an example:
SET_DETECTOR 1
SET_PRESET_LIVE 20
LOOP 3
SET_DETECTOR 1
CLEAR
START
WAIT 2
WAIT
FILL_BUFFER
SET_DETECTOR 0
SAVE “TEST???.CHN”
END_LOOP
The above commands run three 20-second acquisitions and store the data on a disk in
TEST001.CHN, TEST002.CHN and TEST003.CHN.
If the SAVE command is replaced with SAVE “TEST$(Loop).CHN,” then the following files
will be saved: TEST0.CHN, TEST1.CHN, and TEST2.CHN.
228