Download A35 - Ortec

ScintiVision®-32 v2 (A35-B32)
8.3. Measure Sample
This command opens the Sample QA
Measurement dialog (Fig. 202). It contains
a reminder to place the QA source on the
Detector. Click on Overwrite to replace the
last measurement. Click on OK–Start to
begin the count.
The QA source spectra are collected for the
preset time and analyzed automatically. The
analysis results are compared with the limits.
If the result is outside the limits, a warning
is displayed. The results are also stored in the
QA database.
Fig. 202. Starting Sample Type QA
Measurement.
8.4. Status...
The QA status for the currently selected Detector is displayed as shown in Fig. 203. Click on
OK to close the dialog.
Fig. 203. Showing Status of QA Measurements for a Detector.
196