Download Series 982

DIP Switches
DIP Switch Locations and Functions
The Series 982 has several Dual In-line Package (DIP) Switches inside the
control. Depending on your model number, your unit can have as few as
one DIP switch or as many as five DIP switches. Use the rest of this chapter as a DIP switch reference guide.
To set any DIP switch:
1. Remove the control chassis from the case. Release the two tabs on one
side of the bezel, by pressing in firmly on each until you hear the tab
snap. Release the two tabs on the opposite side of the control. You
may need to rock the bezel back and forth several times to release the
chassis.
2. Use the following graphics in the rest of the chapter to locate and identify
each DIP switch and the desired settings.
WATL W
PROCESS
Release
Tabs
Figure 1.3 Press the release
tabs to remove the
controller chassis.
L1
L2
DEV
% OUT
L3
L4
Release
Tabs
DISPLAY
HOLD
RUN
MODE
Release
Tabs
SERIES 988
WATL W
DSPY
MODE
PROCESS
L1
L2
L3
DEV
HOLD
% OUT
RUN
L4
SERIES 989
Release
Tabs
Starting Out with the Watlow Series 982, Chapter 1
WATLOW Series 982 User’s Manual
1.3