1
Download Integrate QuickStart into your System
Transcript
3b Configuration Integrate QuickStart into your System Configuration / Software Advanced Motion Controls DR Series DigiFlex® Servo Drives are configured using the DriveSuite configuration software. DriveSuite can be found on the CD ROM that came with your QuickStart package or it can be downloaded from the Advanced Motion Controls website at www.a-m-c.com/download/softaware/amcds3-5.zip. The basic setup of DigiFlex® servo drives is designed to be user friendly. These instructions will walk you through the steps necessary to configure your drive to your system: Connect to the drive Configure the drive mode. • Torque • Velocity Set Velocity Limits • Position Set Position Limits Save your project often to the Drive Suite\My Projects directory. Assistance for topics not covered in this guide is available through any of the following: • DriveSuite Help files • www.a-m-c.com • Technical Assistance via phone: 805-389-1935 Technical Assistance via e-mail: [email protected]. Note: The full version of the Software Start-Up Guide can be found on the Advanced Motion Controls website under ‘Support/Digital/100series’. It is not needed but could be of benefit for more complete configuration/diagnostic instructions. 14 Advanced Motion Controls · 3805 Calle Tecate, Camarillo, CA 93012 Phone: 805-389-1935 · Fax: 805-389-1165 · www.a-m-c.com
