Download "user manual"
Transcript
Chapter 9 Slave Module(XBL-CSEA) Setting using XG-PD 9.1.2 Online Registration To register communication module using XG-PD in online status, conduct the steps No. 1 and 2 of the off-line registration and conduct following steps. 1) Enter project name in the project name field, select PLC series type and select the PLC CPU type in the CPU type 2) If unable to connect, check the connectivity with the PLC, select [Online →Connect Setting] or click ( ) icon to select connection method. Available connection methods are RS-232C cable, USB cable, Ethernet module and EtherNet/IP module. 3) When normally connected, the submenus of the online menus are enabled. 4) To check up the module currently mounted in the basic unit, select [Online → Read IO Information] or click the icon ( ). And all the communication modules are searched and displayed in the project window. If the modules registered offline differ from the information of the currently connected PLC, or differ from the type of the communication module worked in the previous project, check the change in addition with the above message. 5) The list of the communication modules installed in the product is created in the project window. 9-2