Download MK 2200
Transcript
S1.1 This switch is for selection of overcurrent high-set for Group B 1 = overcurrent high-set enabled. 0 = overcurrent high-set disabled. S1.2 Reserved - not used S1.3 Reserved - not used S1.4 This switch is for selection of earth fault high-set for Group A 1 = earth fault high-set enabled. 0 = earth fault high-set disabled. S1.5 This switch is for selection of earth fault high-set for Group B 1 = earth fault high-set enabled. 0 = earth fault high-set disabled. S1.6 Reserved - not used S1.7 Reserved - not used Soft Switches 2 to 5 Soft Switches 2 to 5 are used to configure the functional characteristic of the contact outputs R2 to R5 respectively. Through these soft switches, an output can be configured to response to one or more events as shown below: 22