Download MK 2200

Transcript
S1.1
This switch is for selection of overcurrent high-set for Group B
1 = overcurrent high-set enabled.
0 = overcurrent high-set disabled.
S1.2
Reserved - not used
S1.3
Reserved - not used
S1.4
This switch is for selection of earth fault high-set for Group A
1 = earth fault high-set enabled.
0 = earth fault high-set disabled.
S1.5
This switch is for selection of earth fault high-set for Group B
1 = earth fault high-set enabled.
0 = earth fault high-set disabled.
S1.6
Reserved - not used
S1.7
Reserved - not used
Soft Switches 2 to 5
Soft Switches 2 to 5 are used to configure the functional characteristic
of the contact outputs R2 to R5 respectively. Through these soft
switches, an output can be configured to response to one or more
events as shown below:
22