Download Installation & Configuration

Transcript
4
Installation and Configuration
DC
Dynamic Concepts Product
00
Always zero
p
0
1
2
3
4
DCI Product ID:
Passport daemon
uniBasic IRIS
uniBasic-N (Niros)
uniBasic-IDOS
uniBasic IQ
nnn
uniBasic port number, in hexadecimal, associated with this queue.
For example, port 15 is displayed as "00F".
See also:
Terminating a uniBasic process
Message queue requirements for uniBasic are based on the number of concurrent
users and overall message traffic on the system. The default values on many systems are sufficient to support a few users, but certainly will need to be increased for
large installations. If they are not configured, uniBasic may fail at start-up, possibly with a message such as "Bad system call."
The following 7 parameters affect message queues on most systems. The actual parameter names may vary:
MSGMNI
Maximum number of message queues. Configure based upon the
maximum number of concurrent uniBasic users plus phantom ports
plus uniBasic IQ users plus one for the passport security daemon.
MSGMAX
Maximum size of a message in bytes; at least 516.
MSGMNB
Maximum number of bytes per message queue. Set to the maximum
allowable value; typically 32768.
MSGTQL
Maximum number of outstanding system wide messages.
Suggested setting is at least 256, but may be adjusted if message activity is known to be greater or smaller.
MSGSSZ
Size (in bytes) of a message segment. Memory for message data is
divided into segments of the defined size. A value of 32 is recommended.
uniBasic Reference Manual