Download Installation & Configuration

Transcript
Installation and Configuration
9
Loading the Distribution Diskettes & Tapes
The Installation Tape or diskette is first copied into the /tmp directory using the
supplied floppy or tape and the instructions printed on the media. The name of the
device used by DCI to make the tape is listed, i.e. /dev/fd096. In many cases, similar computer systems sold by various manufacturers have differing device names.
If you experience difficulty loading the distribution media, contact your supplier to
ascertain the exact device name for the format supplied.
For example, SCO Unix distribution is typically 5.25" diskette. The commands to
load this type of distribution would be:
sign on root
cd /tmp
cpio -iavcdu </dev/fd096
Installation media delivered on cartridge tape may have the bytes reversed. If an
error occurs during the cpio command, try the following command:
dd if=[device]
conv=swab | cpio -iavcdu
where [device] is the device name (i.e. /dev/rtp) shown on the installation tape.
If the command is successful, a list of filenames is displayed as the data is loaded
into the /tmp directory.
If you have additional installation diskettes/tapes for other DCI products, follow the
loading instructions for each, prior to issuing the ubinstall command.
Loading the uniBasic Installation Media
Verify that you are signed on as root, and defaulted to the /tmp directory. Issue the
following command to load the Installation media:
cpio -iavcdu < device name (i.e. /dev/fd096, /dev/rtp, etc.)
uniBasic Reference Manual