1
Download PROFIBUS-DP Master Module User`s Manual
Transcript
9 TROUBLESHOOTING Error codes E564H to E59DH Table9.7 Error codes E500H to E5FFH (Continued) Error Code E564H E565H Error Description Request-not-supported error was detected on the DP-Slave side. E566H Incorrect index was detected on the DP-Slave side E567H Incorrect data length was detected on the DP-Slave side. E568H Incorrect slot number was detected on the DP-Slave side. E569H Incorrect data type was detected on the DP-Slave side. E56AH Action Application error was detected on the DP-Slave side. Access to an access-disabled area was attempted from the DP-Slave side. E56BH Access is not available on the DP-Slave side. E56CH The access was rejected on the DP-Slave side. Check if the request data supported by the DP-Slave is E56DH Incorrect access range was detected on the DP-Slave side. correctly set or not, and retry. E56EH Incorrect request was detected on the DP-Slave side. For details, refer to the manual for the DP-Slave. E56FH Incorrect data type was detected on the DP-Slave side. E570H E571H E572H Incorrect parameter in the request was detected on the DPSlave side. Resource error was detected during read processing on the DP-Slave side. Resource error was detected during write processing on the DP-Slave side. E573H The resource is already in use on the DP-Slave side. E574H There is no resource that can be used on the DP-Slave side. E575H Incorrect parameter exists in the ACK request. E576H E580H There is no alarm for which ACK can be requested. E581H The alarm specified for ACK request is not found. E582H Use of the alarm function is not allowed. Check the alarm status on the specified DP-Slave and retry. Check if the DP-Slave supports the alarm function or not, and retry. E590H E591H E592H E593H E594H E595H Hardware failure E596H Please consult your local Mitsubishi representative, explaining a detailed description of the problem. E597H E598H E599H E59AH E59BH Acyclic communication is executed to the same DP-Slave. Verify that the Acyclic communication is completed, and E59CH There is no executable resource. retry. E59DH There is an invalid parameter setting. Check the parameter settings and then retry. (To the next page) 9 - 21 9.5 Error Codes 9.5.4 Error codes E500H to E5FFH (Error codes generated when reading alarms)
