Download Rev A - AMETEK Programmable Power
Transcript
Operation 3.4 Sorensen ASD Series REMOTE CURRENT PROGRAMMING Remote current programming is used for applications that require the output current be programmed (controlled) from a remote source. An external voltage source may be used as a programming device. When using remote current programming, a shielded, twisted-pair, hookup wire is recommended to prevent noise interference with programming signals. 3.4.1 REMOTE CURRENT PROGRAMMING USING A 4-20MA CURRENT SOURCE The current source coefficient for remote current programming is 16mA/100% rated output with respect to AGND (terminal 9 on digital option board, terminal 20 on SG compatible option board, or terminal 5 on EtherCAT Option Board). The programming current from I_PROG (terminal 11 on digital option board, terminal 16 on SG compatible option board, or terminal 4 on EtherCAT Option Board) it should be from 4mA to 20mA. This yields a coefficient of 1.0% of rated output current for each 0.16mA. See Figure 3-3 through Figure 3-5 for connection requirements. 1 14 AGND 4-20mA Current source 9 11 I_PROG 13 25 Figure 3-3. Remote Current Programming Using Current Source (Digital Option Board) 3-6 M551177-01 Rev A