Download instruction manual

Error Message List
Error
Message
Arc
Discharge
Delayed
Reason
Arc Discharge is
delayed
Inadequate arc power
Thin Fiber
Fat Fiber
Prefuse power or time
is set too high
Insufficient [Overlap]
setting
Too much [Overlap]
setting
Too Tapering
Too much fiber taper.
Fiber
Bad fiber end-face.
Bubble
There is dust
after
executing
Dust Check
function
Heater Oven
Trouble
Temperature
Sensor NG
Prefuse power or time
is set too low
Solution
• Check that the electrodes are in proper
position.
• Execute the [Stabilize Electrode] function.
• Replace the electrodes.
Calibrate the arc power with the [Arc
Calibration] function.
If using the standard mode, adjust or initialize
[Prefuse Power] or [Prefuse Time] settings. For
AUTO splice mode, the prefuse is fixed and
cannot be adjusted.
If using the standard mode, adjust or initialize
[Overlap] setting. For AUTO splice mode, the
overlap is fixed and cannot be adjusted.
If using the taper splice function, the error
message may appear meaning the fiber is
tapered too much.
Check the condition of fiber cleaver. When the
blade is worn, rotate the blade.
If using a standard mode, adjust or initialize
[Prefuse Power] or [Prefuse Time] settings. For
AUTO splice mode, the prefuse is fixed and
cannot be adjusted.
Dirt or dust exists in
optical path.
• Clean the objective lenses by referring page to
28.
• When the above processes cannot remove the
dirt or dust, consult your nearest sales agency.
Heater does not heat.
Consult your nearest sales agency.
Temperature Sensor
may be damaged.
Consult your nearest sales agency.
67