Download "user manual"
Transcript
7. Connection Procedure 4 Parameter group to show is set to Port2: Protocol macro Settings. The setting items of the Port 2: Protocol macro Settings are shown. Confirm that the Port2: Port Settings is set to User settings and other settings are the same as those listed in Section 6.1. *If the settings are different from the above, change the values from the pull-down lists. After changing the values, click the Apply Button. 5 Double-click I/O Map under Configurations and Setup on the Multiview Explorer. The I/O Map Tab is displayed and then the parameters for the Unit are listed. 6 Confirm that data in the Variable Columns start with J01 and the Global Variable is set in each Variable Type Column. *If the settings are different from the above, right-click on CJ1W-SCU42 and select Create Device Variable. 7 Double-click Task Settings under Configurations and Setup in the Multiview Explorer. 20