Download "user manual"

Transcript
7. Connection Procedure
4
Parameter group to show is set
to Port2: Protocol macro
Settings.
The setting items of the Port 2:
Protocol macro Settings are
shown.
Confirm that the Port2: Port
Settings is set to User settings
and other settings are the same
as those listed in Section 6.1.
*If the settings are different from
the above, change the values
from the pull-down lists. After
changing the values, click the
Apply Button.
5
Double-click I/O Map under
Configurations and Setup on
the Multiview Explorer.
The I/O Map Tab is displayed
and then the parameters for the
Unit are listed.
6
Confirm that data in the Variable
Columns start with J01 and the
Global Variable is set in each
Variable Type Column.
*If the settings are different from
the above, right-click on
CJ1W-SCU42 and select
Create Device Variable.
7
Double-click Task Settings
under Configurations and Setup
in the Multiview Explorer.
20