Download "user manual"

Transcript
9. Program
9.2. Communications sequence
This section explains the communications sequence (protocol macro data) that can be used
for the ExecPMCR instruction of this program.
9.2.1.
Communications sequence No.
A communications sequence (protocol macro data) that is registered in the Serial
Communications Unit is identified by a communications sequence number. The Controller
executes the corresponding command on the destination device by specifying a
communications sequence number in the ExecPMCR instruction.
This protocol macro data includes the following communications sequence.
No.
Command name
900
Reading Trigger
9.2.2.
Description
Issues the reading trigger for a bar code.
ExecPMCR instruction input variables
The ExecPMCR instruction input variables for communication sequence No.900 Reading
Trigger are set as follows:
Variable
Port
Name (data format)
Destination port specification
(_sPROT)
UnitNo
Unit number (_eUnitNo)
PhysicPortNo
Serial port number (USINT)
SeqNo
Communications sequence
number (UINT)
SrcDat[] (array)
Send data array (WORD)
DstDat[] (array)
Receive data array (WORD)
Data (Description)
_eUnitNo#_CBU_No00
(Specifies the unit number for the
Serial Communications Unit.)
USINT#10#2
(Use serial port No.2.)
UINT#10#900
(Specifies Reading Trigger.)
WORD#16#0000
(The number of words of send data
is 0.: Specifies that no parameter is
required for the command.)
(Receive data. Setting is
unnecessary)
47