Download Paper - Asee peer logo

Figure 6: Data acquisition configuration interface windows and settings
To connect the sensors to the acquisition unit, the DBK11A card was used. The screw terminals
are pin connections for the analog inputs, and some pins have references voltages (+/- 5V dc, +
15 V dc, and low level ground). An illustration of the connected data acquisition card can be seen
in Figure 7.
Page 8.420.7
Accelerometer
BNC inputs
“Proceedings of the 2003 American Society for Engineering Education Annual
with copper
conference & Exposition Copyright © 2003.
shielding
American Society for Engineering Education”