Download IEI HubMax/HubMax II Install

2.0 UL Requirements
The IEI HubMax and HubMax II controllers are U.L. Listed products and comply with U.L. 294. To install
these products to meet U.L. requirements, all the instructions in this section and throughout this manual
must be followed.
The HubMax System is designed to be wall mounted (surface mounted) with the supplied hardware. The
system must be installed within the protected area in accordance with the National Electrical Code
(NFPA 70), local codes, and the authority having jurisdiction. It should also be located in an area that is
accessible for programming purposes. After the installation is complete, the HubMax cabinet door should
remain closed and locked to protect the contents.
For additional information, see illustration drawing 6225034 Rev. 2.2, dated 3/2/05 located on the inside
of the cabinet door.
In addition, all other interconnecting devices must be U.L. Listed.
A minimum of three (3) user codes must be programmed for controlling access.
Note: The modem interface was not evaluated by U.L. The Panic and Duress functions also were not
evaluated by U.L. The PC software is only used for downloading and uploading data. The PC does not
make access control decisions or monitor the door.
2.1 Tamper Requirements
To meet U.L. requirements, a U.L. Listed tamper switch must be installed in the cabinet of HubMax
systems. The tamper switch must be mounted inside the locked cabinet and must activate if the cabinet
door is opened. The tamper switch must be wired to an alarm panel or other device that sounds an alarm
and/or prevents anyone from gaining access through the protected door.
IEI recommends using a Sentrol 3012 tamper switch (not provided).
To use this tamper switch, simply clip the switch on the side of the cabinet on the interior, then wire the
leads to your alarm device using the appropriate U.L. type cable. See diagram below.
Page 7 of 48
www.ieib.com
HubMax Installation/Programming Manual
Document # 6065034, Rev. 3.4, D4b
Fax Document Number: 5034