Download Test Tool User Manual

Transcript
Get Control Accelerometer Test Tool - Version 5.0
Figure 5 shows details on attaching the 300 mm Mounting Plates to the Vib Tool. The bottom plate is
fastened directly to the enclosure. The top plate is mounted with springs between the enclosure and plate.
The top screws are left loose, to allow the unit to align with wafer slots in the FOUP. Once the unit is place
into a FOUP, the hex head or hex socket screws are tightened down (using a 3/16" socket or hex wrench)
to firmly grip the slot fingers. Tighten the screws such that the Vib Tool is secure to the FOUP. Over
tightening may damage the FOUP and/or the Vib Tool.
Figure 5 - Test Tool with 300 mm Mounting Plate
3.2
Mounting Brackets for 150 mm Reticle Pod Installation
When packaged for 150 mm reticle pod installation, the Vib Tool is shipped with all required mounting
brackets attached.
7