Download AH401D User`s Manual

AH401D User’s Manual
4.3 Hardware Reset
A hardware reset of the AH401D picoammeter can be performed by pushing
the RESET button, accessible with a thin pen-tip or a needle through a small hole on
the rear panel of the device (Figure 7).
Reset
Button
Figure 7 – Hardware reset button
Once the RESET button has been pressed and released, the AH401D internal
processor re-initializes, reloading its firmware from the FLASH memory and starts
operation again.
Performing this reset operation is equivalent to executing the Remote Hardware
Procedure (see section 2.4 for further details).
41